Behavior of Gas-Liquid Mixture in a Downward Orientation of Vertical Pipe
Keywords:
Vertical gas-liquid flow, void fraction, wire mesh sensor, probability density functionAbstract
This paper describes the application of the erratic concept in the identification of two-phase gas-liquid flow patterns and transitions in a large vertical riser. The analyzed data in this paper were from the experimental conducted in the 4-inch diameter pipe. In the experiments, vertical gas-liquid two-phase flow was studied in a large cross-sectional area. The complete analyses covered the range experimentally attainable .
Usually, the flow pattern identification, and gas void fraction of two-phase flows are based on visual observation of phase distribution. While visual flow pattern identification may be sufficient for a number of instances, for many circumstances these methods are inappropriate or too biased. The objective of this study is to apply probability density function (PDF) and local distribution of averaged void fraction concepts, on experimental data of dynamic signals of gas-liquid two-phase flows, in an effort to identify and interpret the creation and transitions of flow pattern in downward flow. These methods will possibly give a favorable way in the identification of flow behavior. The plots of probability density function (PDF) confirm that, a bubbly to intermittent flow transition was occurring at all positions. The flow regime observed at the bottom region of pipe was accompanied by a wide base spanning from 0 to 0.6. The existence of large bubbles in a liquid phase contributes to the wide base of void fraction values. Annular flow was a dominant type in a downward flow, particularly when gas superficial velocity increased to higher rates. The achieved results were in good agreement when compared with data of local gas void fraction distribution, obtained from wire mesh sensor (WMS) technique.
References
A. A. Almabrok, “Gas - Liquid two-phase flow in up and down vertical pipes,” PhD Thesis, Cranfield University, 2014.
Barnea, D. (1987). A unified model for predicting flow pattern transitions for the whole range of pipe inclinations. International Journal of Multiphase flow, 13, pp. 1-12.
Cheng, H., Hills, J. H. and Azzopardi, B. J. (1998). A study of the bubble-to-slug transition in vertical gas-liquid flow in columns of different diameter. International Journal of Multiphase Flow, 24, pp. 431-452.
Cheng, L., Ribatski, G., and Thome, J. R. (2008).Two-phase flow patterns and flow-pattern maps: Fundamentals and applications. Applied Mechanics Reviews, 61, pp.28.
Hewitt, G.F. and Jayanti, S. (1993). To churn or not to churn. International Journal of Multiphase Flow,19, pp. 527-529.
Kataoka, I. and Ishii, M. (1987). Drift-flux model for large diameter pipe and new correlation for pool void fraction. International Journal of Heat and Mass Transfer, 30, pp. 1927-1939.
Nicholas P. Cheremisinoff (2000). Handbook of chemical processing equipment, Butterworth-Heinemann, USA.
Olerni, C., Jia, J., Wang, M. (2013). Measurement of air distribution and void fraction of an upwards air-water flow using electrical resistance tomography and a wire-mesh sensor. Measurement Science and Technology, 24, pp.9.
Taitel, Y., Barnea, D. and Dukler, A.E. (1980). Modelling flow pattern transitions for steady upward gas-liquid flow in vertical tubes. The AIChE Journal, 26, pp. 345-354.
