Selection of HRSG Parameters for the Triple-Pressure Combined Cycle Power Plant Based on ant Colony Optimization Algorithm

Authors

  • Muammer Alus Department of Mechanical and Industrial Engineering, Faculty of Engineering, Elmergib University, Alkhoms, Libya
  • Khaled Abdusamad Department of Mechanical Engineering and Energies, School of Engineering Sciences, Libyan Academy for Postgraduate Studies, Janzour, Libya
  • Moammer Hamed Department of Mechanical and Industrial Engineering, Faculty of Engineering, Elmergib University, Alkhoms, Libya

Keywords:

combined cycle, heat recovery steam generator, pinch point, optimization

Abstract

A new method for the thermoeconomic optimization of triple-pressure heat recovery steam generators (HRSGs) for combined cycle power plants (CCGT) is proposed in this paper. The new optimization method is based on the ant colony optimization algorithm (ACO) and by applying the global optimization software (MIDCO). The optimal values of the most influencing operating parameters are obtained by maximizing the objective function while satisfying a group of constraints. The proposed method is based on optimization of the following operating parameters: the temperature difference between the gas and steam (pinch point) and the drum pressures in the HRSG. The purpose of the thermoeconomic optimization was increasing of the annual cash flow. The optimized combined cycle was compared with the initial case. The results show that there is a potential for considerable improvement of the plant economy when compared to the initial case, where the overall thermal efficiency increased by 0.54 % and the annual cash flow was increased by1.53M$. In addition, the new method could be suitable for research work of the power plants optimization.

References

. Alus M. & Petrovic MV. (2012). Optimization of the triple-pressure combined cycle power. Thermal Science. 16(3), 901- 914.

. Godoy E., Benz SJ., Scenna NJ. (2011). A strategy for the economic optimization of combined cycle gas turbine power plants by taking advantage of useful thermodynamic relationships. Applied Thermal Engineering. 31(5), 852-871.

. Ahmadi P., Almasi A., Shahriyari M., Dincer I. (2012). Multi-objective optimization of a combined heat and power (CHP) system for heating purpose in a paper mill using evolutionary algorithm. International Journal of Energy Research. 36(1), 46-63.

. Behbahani-nia A., Sayadi S., Soleymani M. (2010). Thermoeconmic optimization of the pinch point and gas-side velocity in heat recovery steam generators. Journal of Power and Energy. 224(6), 761-771.

. Ahmadi P. & Dincer I. (2011). Thermodynamic analysis and thermoeconomic optimization of a dual pressure combined cycle power plant with a supplementary firing unit. Energy Conversion and Management. 52(5), 2296–2308.

. Valdes M. & JL. Rapun JL. (2001). Optimization of heat recovery steam generators for combined cycle gas turbine power plants. Applied Thermal Engineering. 21(11), 1149-1159.

. Rovira A., Sánchez C., Muñoz M., Valdés M., Durán MD. (2011). Thermoeconomic optimization of heat recovery steam generators of combined cycle gas turbine power plants considering off-design operation. Energy Conversion and Management. 52(4), 1840–1849.

. Franco A. & Russo A. (2002). Combined cycle plant efficiency increase based on the optimization of the heat recovery steam generator operating parameters. International Journal of Thermal Sciences. 41(9), 843–859.

. Valdes M., Duran MD., Rovira A. (2003). Thermoeconomic optimization of combined cycle gas turbine power plants using genetic algorithms. Applied Thermal Engineering. 23(17), 2169–2182.

. Schlueter M., Egea JA., Banga JR. (2009). Extended ant colony optimization for non-convex mixed integer nonlinear programming. Computers & Operations Research. 36(7), 2217-2229.

. Schlueter M., Egea JA., Antelo LT., Alonso AA., Banga JR. (2009). An Extended Ant Colony Optimization Algorithm for Integrated Process and Control System Design. Industrial & Engineering Chemistry Research. 48, 6723–6738.

. Sukru B., Recep O., Zehra Y. (2003). Condenser Optimization in Steam Power Plant. Journal of Thermal Science. 12(2), 176-179.

. Silveira JL. & Tuna CE. (2003). Thermoeconomic analysis method for optimization of combined heat and power systems. Progress in energy and Combustion Science. 29(6), 479-485.

. Attala L., Facchini B., Ferrara G. (2001). Thermoeconmic optimization method as design tool in gas-steam combined plant realization. Energy Conversion and Management. 42(18), 2163–2172.

. Valdes M., Rovira A., Durán MD. (2004). Influence of the heat recovery steam generator design parameters on the thermoeconomic performance of combined cycle gas turbine power plants. International Journal of Energy Research. 28,1243–1254.

Downloads

Published

2023-01-28